Self Closing Door Hinges Instructions

How to install a self closing door 1.

Self closing door hinges instructions.

You can then remove the hex wrench and allow the spring to naturally unwind. Using a hex wrench open the spring so you can see the tension pin. Ask a friend to hold your door in. If the holes align you can simply attach the hinge using the screws it came with.

Self closing hinges take the place of regular hinges. Close the door completely. A spring loaded hinge should only be removed when the door is closed to avoid it slamming. Insert a hex wrench into the.

Start by removing the locking pin photo 1. I ll bet that you never knew you could adjust a self closing door hing. If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers. Changing tension with a hex wrench 1.

You may have to chisel the edge of the door to get a new square cornered hinge to fit in mortises machined for round cornered hinges. Remove the locking pin. In order to tighten the hinge spring first close the door. If you re using one spring.

Stand on the side of the door with the hinges and shut the door until it latches. As mentioned previously the door should close smoothly and fully with little noise. Then remove the pin using pliers. Get free shipping on qualified self closing door hinges or buy online pick up in store today in the hardware department.

Unscrew the locking screws from the top hinge. Screw the spring hinges to the door so that the slotted section on each hinge is on top. Then add or release tension until you get the proper close rate photo 2. Refer to the specifications that came with your hinges to determine how many spring hinges you need.

When you properly attach the hinges to the outside of the door and. Installing a self closing hinge first place the hinges onto the door. If the door does not close fully then you need to increase the tension. If you plan to use self closing hinges take the original middle hinge to your home center or lumberyard and find self closing hinges with plates the same size as the ones already on the door.

Step 2 increase the hinge tension. If the door closes fast and with a bang you need to loosen the hinge spring tension.