Schlage Connect Door Lock Wont Connect To Wink Hub

The keypad should light up.

Schlage connect door lock wont connect to wink hub.

The lock will blink an orange light for a few seconds then you will get a green check mark on the lock as well as a green flash of light on your wink hub wink hub 2. List of products included in this video. When you have successfully connected your devices you will see a flashing green check mark on the lock. In the top right hand corner there s 3 dots click that and choose z wave exclusion.

Start by opening up the door keeping it unlocked and press on the schlage button at the top of the keypad. I went and replaced the lock thinking something went wrong with it but after installing a new lock it still wont connect. Schlage lock won t connect to hubitat or wink. They have yet to suggest anything to try.

I tried moving my schlage lock from my wink hub over to my hubitat. Connect it to your smarthome hub. The lock should now be ready to go for manual usage. In the new app click your hub from your dashboard.

None of the 3 locks will connect. If successful the deadbolt will extend and retract. My app only shows one lock. It began to initialize and then got stuck and never finished.

When used with your z wave compatible smart home automation hub alexa connects to your schlage connect smart deadbolt so you can lock your door and check whether or not you locked up before you went to bed by just asking. I cannot set up the house lock and hub. Get instant notifications whenever the door is unlocked. Use amazon alexa to control your lock with your voice.

Congratulations you are connected to your schlage touchscreen deadbolt. And you may be able to completely unpair your lock which allows the lock to be paired again with your hub. I tried several more times and no luck. Bmott0817 april 24 2020 8 17pm 1.

Then run the pairing command on your lock. I ran a exclusion and it did pick up the lock and removed the unknown device. The wink app will also indicate that it has found the lock. I talked to wink and went through troubleshooting to no luck.

Because the schlage connect is powered by z wave you need to pair it with a smart home hub like wink to extend communication with your home s wi fi. This allows you to communicate with your lock via the wink app when you are remote. I have reset the locks the hub is within a foot when i try to pair i have a zwave device 3 feet away that is paired new batteries in the locks uninstalled and reinstalled the new st app tried with new and old st app excluded get notification on app it worked and lock shows green check included lock. To sync your schlage connect smart deadbolt with z wave plus to your wink hub open the wink app on your mobile device and follow the app s instructions.